Hondata

I wasn’t planning to use this for closed loop. Just want to be able to see the voltage/AF. I hope using ELD will able for me to see AF.

It's a JDM P72 ECU.

I wasn't using the factory O2 pin, it was the Ch.0 Analog and Ground.

But I can try the ELD spot if that's what I should try.

ECM AFM1000

Serial # S300J 5464

S/W version 2.6.7.0

I don't know the wideband specs for the current but it did measure ~2.4 V during idle using volt meter.

I also add 1V offset, but it this change did not reflect in the Analog 0 Display. Are the settings even right?

No Input even when set to raw voltage in Analog 0 sensor.

With the analog harness disconnected, there is measured voltage out. Using this for AFM1000 Wideband.

See attached cal and datalog.

Well, ZR9 in the knockboard as it is hitting C17 of S300. I dont think either is bendable.

No actual picture at the moment, but it's a JDM P72. The ribbon is starting to hit C19 and ZD1 components if the knock board. Can't mount flush to the ECU case.

Yes i did. Also, the knockboard ribbon seems to be impossible to fit between the board and the s300. It' hitting a few components. What's the workaround? The instruction only mention about the ribbon not to be caught or bent

I notice that there are circuits on both sides of the board. And the male pins that came with the the s300 seem to be only for the backside.

Does it mean other side of the board not suppose to be touching the pins? This seems to be different from the 'socket' types as the pins are still exposed ...