Hondata

Seems to have fixed the issue. Just going to check if it does it with my stock calibration and if so I'll work off the base map (I'm not far from stock anyways).

my serial # is 34385, Currently running software 2.5.6.0 and the ECU was socketed by HA motorsports (who also provided the new ECU).

Alright, once my tuner tells me how to do it I'll try that.

As an update I wanted to list some observations I've made. With the S300 plugged in incorrectly the car had the surging idle and other issues listed in my other thread but it had no rpm limit and I could drive the car normally. The 4 pins ...

This is the calibration that has been running the car

This is the datalog taken of the car idling and me revving it.

I'll get that ASAP but for reference it's just a simple N/A H22 with bolt-ons.

Forgive my noobness but how do I post those to a forum?

I have an issue with my vehicle not revving above 1500 rpm's and this only started after fixing another issue ( Cel light, idle surging and unable to read the CEL from Smanager). I have no CELs and no loose connections that I can see but the engine will not allow me to rev above 1500 rpm's while in ...

Alright so I am having an issue which may or may not be related to S300 after getting the other symptoms taken care of. Do I post it in here or make a new thread and if a new thread is needed which section would be most appropriate?

I don't have a picture of it but I checked my plugs (same ever since I swapped the engine) and they are a resistor type.

ok I solved issues, the surging I was experiencing and the CEL have both went away. I had to re-seat the S300 on the pins.
I haven't checked yet to see if it connects to Smanager but two major issues are gone. I supposed if I have further issues I'll
make a different thread for them.

ok saved it and then I'm assuming you meant upload from the "online" button but the upload button was not highlighted

yes, I finally figured out how to close everything and yes, when I do as you instructed I am able to bring up the table which I think was fuel.

I click online, the drop down pops up and I click download. A small box appears asking if I want to save changes to the calibration, I click no right?

This is all I see when I go into the "online" and click "download"