Hondata

Sounds good, thank you. Ove this weekend I datalogged directly to the laptop, and everything recorded and replayed correctly - including all OEM sensors and analog inputs. I did not try using the on-board datalogging.

And attached here is the calibration file and example on-board datalog. The time scale is roughly 2x real time (2 minute datalog vs 1 minute actual time), and all sensors seem to log ok except for the four analog inputs.

My s300 serial number is # 40689. The SManager software version is 2.8.2.0 Build 3207. I am logging on-board at 25hz, is that too fast of a rate for the on0board logging to handle with the addition of the four new sensors?

Hi everyone, I have a recent on-board datalogging issue that has popped up. For the last few years, the on-board datalogging has worked great. I activate/de-activate the logging via a switch connected to the service connector, and have that setup in the parameters. Typically, I will log around 4-6 1 ...

As long as there is access to setup device's CAN settings to coordinate to that of the S300, I don't think this would be too much different than connecting the S300 to a mounted dash display via CAN bus connection. Unless I'm missing something. I have an email in to ECUMaster and will post their ...

Has anyone tried using the ECUMaster CAN bus to bluetooth adapter, as a means to get the additional Hondata analog input sensor readings (extra temp, pressure, etc) to output via bluetooth, for use on any generic app? In theory, it seems like it would work, as the device receives CAN bus signal and ...

I think I am having the same or similar issues. With my autocross car, I have noticed recently that SManager will always work correctly and connect to my P28 ECU with no issues, when I am sitting in my garage and the laptop has a wifi connection. I've noticed recently that if I try to pull datalog ...