Hondata

Thanks a lot for your help Spkunster.
I found what is the problem I used the analog output 1 of the Lc1 who give 0- 1v thats why
Now I used the analog output 2 who give 0-5v and I have normal AFR reading by ELD pin.

But I want to use analog input of the S300 (AN0) and I have funny values.
I ...

A25 for power and A26 for ground

Yes today I removed r136 and r138, but not change nothing.
The value of AFR in smanager and the gauge stay different.

I did try with logworks too.
and Logworks values are same than the gauge's values :(

I am desperate how its so hard to have good AFR reading in smanager

thank you for your reply Spunkster.
I did try D10 pin and Analogic input AN0 too, but the value by theses two ways are very differents than the value that i have with the gauge.
I dont know why i can't have the same value at the gauge and in the logger.

At this time I try to tune just the idle ...

Hi all

I'm newbie with Hondata S300 and I need some advises.

I have a complete P06 ecu bought with Xenocron.
I tried to use the yellow wire of the LC1 with D14 pin but it seems not work very well.
My AFR value stays à 18 and its very different of the value that i have with the gauge linked on the ...