Hondata

Ok I understand that but I AM having an issue... Every prb cal I try does the same thing. I can fix it myself but I don't know where to start. A suggestion on some things to change just to get it to idle would help.

So I tried uploading a prb cal and the car does the same as I described before, starts and dies right away... I used the cal that was as close to my setup as possible. When I run my old base map it runs just fine. Ive shut the immobilizer off and still have the same results. Is there something Im ...

Will do, Thank you

Ok. I just finished my build and have not dynoed. My current calibration is a base tune just to get started and check functionality of cooling system, trans, etc... In your opinion would importing get me close enough to get the car started and such or should I start from scratch? If from scratch ...

So if I am understanding this correctly, a PRB calibration will work on my PNF ecu? If this is the case can I import my tables from my current tune to a PRB calibration to use in an EP3? I have loaded PRB cal to my car before and it starts then dies right away and runs very poorly when I keep it ...

Kpro v4 serial#44845 02 EP3 K24 JRSC PNF ECU. Why can't I activate Flex Fuel on my calibrations?

There is a pretty extensive DIY about this very topic on Clubrsx.com if you were not aware. I used that write up to install and configure water/methanol injection for my K24A2 JRSC RSX.

Thanks for the reply! I was not aware of this. I went searching for it but it seems that clubrsx and family are ...

TerpATX wrote:Did you need to reset the immobilizer or was it the same?

I kept everything the same, didnt have to do anything with the immobilizer, just had a "special" moment

I have a K24A2 with a JRSC that I am running water/meth injection using the nitrous controls in Kpro4. I would like to suggest a test feature for these controls to confirm correct wiring and function instead of driving it to find out. I'm sure I am not the only one who has thought of this but I've ...

Voltage drop when switched to "on" position... I tested voltage on the battery with the switch off and it passed just fine but did not test with ignition on, foolish mistake. Hooked my charger up and bingo was his namo... I work on multi-million dollar overly complicated cranes for a living and ...

*RESOLVED*

I just got my upgraded ECU yesterday. I previously had V2 which had the car running well the weekend of the 28th. I installed the new ecu and wanted to confirm my calibration so I attempted to connect and it will not show ignition is on even in the run position. Checked grounds, checked voltage ...