Hondata

JJA12 wrote:

Spunkster wrote:Prameters, Protection. Set it to 5 inches of vacuum.

By doing so, what will be the limited rpm?

I've observed that my car will not go WOT; which is exactly what I wanted until the car warmed up.

Spunkster wrote:Prameters, Protection. Set it to 5 inches of vacuum.

Thank you.

petah wrote:better way to protect your car is dump your fiance and find a girl that will treat your car the way you would.

No.

I'm only thinking of this because the other day my fiance flogged my car as soon as she fired it up & backed out of the driveway..

How about implementing an alternate Rev Limiter when the engine is still cold? For example, be able to set the Rev Limiter to 4k when the ECT is below normal operation ...

In KManager under the Closed Loop tab, did you disable P1167? I've noticed that when you disable that, it also disabled P1166. 1166 = Primary o2, 1167 = Secondary o2

Tryfe,

Yes similar effect It's like being on first.


Wayne,

Find attached 2 datalogs as you requested.

Thanks for the help.

Frank
Looks to me like you're foot is on the gas pedal when you decelerate. I'm sure whenever you're feeling the jumpiness, it's when your TPS goes up, which mean's you ...

I keep mine plugged into the ECU and running just under the center console to my E-Brake where I keep the other end tucked in there. No chance of anyone stomping on it and i don't have to reach into my glove box to connect it either.

Is it the same as when you're barely going 1mph with just the clutch engaged and no throttle?

Allow multi-line notes.

wo0! :D

Everytime I upload my calibration, my idle is always screwy for the first few times I run the kal. But it smooths itself out to where I want it to be.

v10?

When I datalog, I leave nothing open but the Sensors window with KManager maximized. I get high fps like that.

ares650 wrote:

tryfe wrote:and smoothing there now is! Hmm...now how to go about using it..

for the kmanager their is inperplteing but no smoothing.
Interpolate, makes a stright line between points. Smoothing is a foumla that follow your flow and put your ponits into a smoother layout.

Version 1.2.0.9 has smoothing now..

Smoothing only works for me on one table. I'm trying to smooth my fuel curves and it will only smooth my 0 degree table. Is it not supposed to work on the other angles? I've even tried checking, "Edit all tables."

and smoothing there now is! Hmm...now how to go about using it..