Hondata

I suspect that something's wrong with this new version,
My car idles @ 16" with an RBC Manifold. Before the software change it was around 20-22".
I'm tempted to try going back a couple versions (but that's not recommended) so what now?

And further more, today I helped a friend Dyno tune his car ...

Thanks for the quick response, but I think I did that also. I'll try it again.

BTW. what pressure reading should I get at idle at sea level? I'm about 4' above sea level here and the MAP reads 16"...

96 spec DC2 Type R
JDM K20A
PRC ECU
4-1 Swap Header/ no Cat
A rear appearance for me on this forum,

Everything was fine until I updated to 1.3.2
now there's a 11:1 A/F that I can't shake....
The STrim says -27% all the time at idle,
and even if I take out the 27% the A/F would be around 14:2
and ...

Yes I've all that, It just does not seem to work. for example, E18 Should be 12volts with compressor off, I'm getting 0.02volts on or off. but the compressor does not switch the relay.Maybe I'll upload my hook up?

It's a 96 Spec JDM Integra Type R.

With the A/C on input I'm getting the idle up, but E18 refuses to ground the compressor relay. When I change the setup back everything works fine (well except for the idle up). So I tried, "Y" the A/C input and compressor relay ground, and that kinda works, but the load of the compressor is too high ...

Hi, Does the A/C idle up feature work with the PRC ecu?

Hi, do you guys have a diagram for hooking up this option:?: