Hondata

Looking at Digikey for these chips and noticed that they had some different memory speed for this chip: 70ns, 90ns, 120ns, 150ns, and 200ns. Can someone advise which speed I should be ordering?

Yes, I was datalogging. The box was solid.

I have a check engine light that came on while I was driving and happen to be logging data (S200 hooked to a USDM P72 on a B18C 93EG). I clicked on the Error Codes and could not see any error codes, but the CEL was on. Does anyone have any ideas?

So, can anyone comment about the timing map? I went to an authorized Hondata dealer, so I would assume that the timing was right, but seeing the advance go up to 40? seems high.

Nope, I just used regular xlpe cable. Do I need special EMI shielded cabling?

I just wanted to bring this up again before I spend money to replace the O2 sensor.

Shouldn't there be more voltage range on the O2 sensor? Is this an indication that the 02 sensor is bad? On my swap, I had to extend the wires on the O2 sensor...

Is there any way to do some troubleshooting on the ...

Do you see why there is ignition knock retard at idle?

I recently purchased a Hondata S200 system with a dyno tune on my EG B18C. Today was the first chance to take it to the track. I went 1 Sec. slower than I had gone last Sept. Below is the HondaLogger file of that run. It seems that the Ignition Knock retard while idling is .25? (Lambda 0.60). When ...