Hondata

I'm still not able to get the values to match up. I have a P28 so it might not work with the ELD plug so I might have to just do it the other way with only open loop

Thanks I'll try that.

I am trying to get my Innovative LC-1 to work with hondata. I have butt connected the Aux wire that comes from the LC-1 to the ELD on my P28 Ecu. So the Aux is connected to the ELD wire going to the ECU.

I am trying to figure out how to get hondata to read the wideband signal from the LC-1. I have ...

Spunkster wrote:Have you disabled the knock sensor?

Thanks that was it but now i have another question but I will post up a new thread :D

I am having some problems with my P28 w/ s200. The car is running with the p28 s200 w/ ostrich but I am getting a CEL and I have jumped the CEL but its not giving me any codes. The s200 box has a solid red light. Is there something that I havent not checked in the options in the rom editor? I havent ...

The interface cable you are talking about is the one that connects the blue box to the ecu?

When the check engine light comes on its just for a split second, and as far for the box its still solid. There are no error codes, they dont show up at all

thanks

Could you tell me if there are any settings that i need to change on the enhanced willem board? I did the dip settings and set the chip setting to at29 chips, but after i burn the rom on the chip and put it back on the car it starts acting funny. I would drive fine for like 10 mins and then the ...

Im using the Rom editor V3.6.4.0 version 3.0 and the program that burns the rom is willem eprom m51 version 0.97g

I was wondering if anyone has used another programmer besides the pocket programmer? The reason why i ask this is because I have been having problems with burning a chip with another programmer. I have a Enhanced willem programmer on the pcb3b board and I have had no luck with it on the hondata, but ...

I seem to occasionally get the car to run without the cel light turning on but now im having the problem with the warming idle. When i first start the car when its cold the rpms would go up to 1700 for a few secs and then drop down close to my target idle but the engine hasnt warmed up yet. I have ...

The laptop im using is a compaq and the light remains solid..would the serial to usb connector make this occur? because i am not using a keyspan converter its a different brand

thanks to everyone who has helped me this far

I have just noticed that when I connected to the ecu with hondalogger or the romeditor while the car is running or when the key is in the on position the cel light turns on and stays solid but when I disconnect from the ecu the cel light turns off. Why is this happening?

I have made several basemaps already and they all have the same problem....Im clueless right now

Nah its not running in Limp mode...its revving pass 3.5k...I just cant figure it out...the cel light is just ramdomly coming on and off and the car is dropping rpms and then jumping back up when the car first started....the sound of clicking when the cel comes on....Is it possible that the ...