Hondata

Hello

It?s a new chip with basemap.

I have remove the jumper J12.but it changed nothing. (Led flashing)

I have after times ,chip removed and the car started and ran exactly the same as with chip.

can be also because of the OBD adapter???

Thanks Nico

Hi,

It?s a new Chip, the s200 is also ok.
it can be an error in the Conversion Harness (OBD0-OBD1) ??

The car runs ,however the LED continues to flash.

Have you a Link for Distributor OBD0-OBD1 Instructions??

Thanks Nico,

Hello

Is correct, is a european ECU.
Then I will remove J12.For what is this resistor???

What still the problem with my red LED could be???(It lights long and fast out,......,.......,.......)
but the car starts, runs however not correctly.

Thanks for your Answer,
Nico

Hello

I have a JDM P28 ECU.
I am to remove J12 and J4 ????or only J4.
Where is exact J4??is it over IC2.

Thanks
Nico[/quote]

Hello

I had this problem already for one month (Red Led flashing).
Bought me a stock P28 Ecu, And I have it change (chiping) for Hondata.
The s200 controlled a friend in its car, it is ok.and it provided a new chip for me.

But, the red LED flashes still. :cry:

What can still be ...

Hello

I have a Crx 1991 DOHC V-TEC 150PS with Turbo and Hondata P28 with S200 (Boost,Datalogg.), 440ccm Peak and Hold Injectors, OBD0 to OBD1 Conversion Harness.

The following problem:
I would start the first time (after the turbo change).does not start however.

1.gasoline pump does not start(is ...