Hondata

Okay, will pick up new injectors this week and post updates, thanks.

Stock 310 injectors.

Which map should I run? Im not planning to run too much boost, maybe 8 only for now. I need to do some quick pulls for a real tune.

Your primary o2 sensor is not reading. If you have just changed something in the engine, check everything for broken or pulled wires.

02 is replaced. No more CEL, but the thing is whenever I WOT it immediately stops building boost (Max I got was maybe 1-2psi) making the RPM stop wherever it's at ...

That means there is a problem with the primary oxygen sensor. You should follow the troubleshooting steps in the factory service manual (Helm's Manual) for that specific error code.

Without the calibration and datalog showing the issue it is hard to say what else is going on.


Here is the cal ...

Hello mates, I have installed a turbo kit, and now I have fuel status 8, code p0135, upstream sensor. Car is also in Limp mode, which wont go past 4k RPM. All sensors are checked/plugged in, no oil leaks. What is the cause of limp mode? Not getting enough fuel? I am not sure what happened.