Hondata

Hello.

I recently sold a PRB Version 2 Kpro in order to purchase a new Version 4. In order to re upload my existing calibration to my new Version 4 K pro i need to buy a PRB Kpro ecu? Are there any diferences regarding the serial numbers of the ecus ?

For reference i was running that ecu on an ...

Hello,

When enabling knock sensor flashing MIL, will this disable the other uses of MIL ( For example engine light for o2 sensor problem for example or lean protection light).

Because i had an engine cut out and when i datalog i found really lean afr at high revs which must enabled the lean ...

thx for the fast reply.So it shouldnt at least keep constant the MAP pressure value(ex. 98KPa) through out the rev range ?

Hello. I have an issue with MAP values decreasing as the revs increase on WOT. What can be the cause for this? Can this be due to a leak or something?

Vehicle. K20A Dc5 Jdm
Mods: Gruppe M intake,OEM TB,RBC inlet,Toda manifold,Buddy club pro spec 3 exhaust,Kpro v2

Hello,sorry if this topic has been covered again but i would like to ask if is possible to use the aem uego with the Kpro v2 in order to use the wideband for close loop. Or is it not supported in kpro v2 and i will use the uego just as an extra sensor for the gauge afr reading only ?

Thanks in ...