Hondata

Is there some public info chart to get that configuration please?

The only can bus from Honda info I found was for the FN2 model

thanks

RIght

So.. I'm needing to config the Smanager and the AIM device selection like a Motec dash? In the Smanager you have the two options but the Race studio from AIM only have HONDATA "KPRO" protocol to choose and it's from RS signal , right?

In MOtec models show , M4-M48 models and M800-M600

Thanks

Yes sir ,

We have CAN+ and CAN- wires on our Strada MXL module. They announces CAN protocol with ECUs like Motec , EFI , Bosch , etc.

thanks

Thanks hondata,

So , I found another post talking about the CAN setting with MOtec Dash , It's same setting method for the AIM?

Hi Hondata

We are working with a S300 V3 and AIM MXL model. The gauge shows all ECU parameters but we have 2 analog inpus with the oil press and temp reads. We'd like to show these 2 channels on the display but they are not availabe in the channel selection window on the Race studio

Is there any ...

Yes Sir ,

but its not a cam timing problem , the aligment marks and cam degree it's ok , the problem is on the intake cam signal sprocket , it's not aligned with exhaust well and have no regulation option as you know.
We had that issue with another cams in a Kpro system and using the DTC error ...

Hi Hondata,

It's possible to dissable the DTC P0341 code from the ECU like the K-pro? I can't see any option to do it.

We have some issues with a JUN Type 3 cams , double check the degree and all it's OK but the ECU fall into DTC code.

thanks