Thanks for replying quickly but I ended up fixing it.
After replacing all those sensors (which I believe the MAP sensor and bad ground was the original issue) and removing my fuel pump a couple times when I was inspecting everything I must have loosened a wire on the fuel pump housing and it was ...
Search found 4 matches
- Fri May 29, 2020 2:58 pm
- Forum: K-Pro / KManager
- Topic: k20 cranks but won't run diagnostics
- Replies: 2
- Views: 2297
- Sat May 23, 2020 6:43 pm
- Forum: K-Pro / KManager
- Topic: k20 cranks but won't run diagnostics
- Replies: 2
- Views: 2297
k20 cranks but won't run diagnostics
Hey hondata people,
I need help figuring out why my EP3 will crank but won't run. History the car ran fine and I parked in the garage and the next day it would just crank and not start. Attached is a log I made of me trying to crank the car a few times, was wondering if anyone might spot something ...
I need help figuring out why my EP3 will crank but won't run. History the car ran fine and I parked in the garage and the next day it would just crank and not start. Attached is a log I made of me trying to crank the car a few times, was wondering if anyone might spot something ...
- Wed May 20, 2015 1:31 pm
- Forum: K-Pro Calibrations
- Topic: k20a3 jrsc jumpy a/f at idle
- Replies: 0
- Views: 3251
k20a3 jrsc jumpy a/f at idle
Hey guys,
I'm pretty new to kpro, but I've been reading up a lot on it. I'm working towards getting a street tune, but currently I've run into a few issues.
First off the issue is my a/f ratio seems to be everywhere from 11 -17 during idle. I know this is wrong and ideally I would want a target ...
I'm pretty new to kpro, but I've been reading up a lot on it. I'm working towards getting a street tune, but currently I've run into a few issues.
First off the issue is my a/f ratio seems to be everywhere from 11 -17 during idle. I know this is wrong and ideally I would want a target ...
- Wed May 20, 2015 1:05 pm
- Forum: K-Pro / KManager
- Topic: lamba fuel table not displaying values
- Replies: 4
- Views: 2705
lamba fuel table not displaying values
Hey guys,
I was doing some datalogging and I notice when I click on the "display lamba values" (shift+f4) that I'm getting a blank table. Was wondering whats up?
I'm using a plx wideband wired into the eld and kpro4, all other O2's are disabled.
any help on figuring out how to correct this ...
I was doing some datalogging and I notice when I click on the "display lamba values" (shift+f4) that I'm getting a blank table. Was wondering whats up?
I'm using a plx wideband wired into the eld and kpro4, all other O2's are disabled.
any help on figuring out how to correct this ...