Hondata

I got my gm sensor wired up, but i am unable to read temp all it shows is voltage? Yes i have the resister wired in, any ideas? It also comes up as voltage on the datalog too, i posted some pics of my settings, not sure why the pics are sideways after upload

Thanks again for the help

Hello, just wondering if this will work with S300 to datalog, The speed sensor is powered by a +5V supply and the return signal is a variable frequency square wave that has maximum amplitude of 5V and has a 50% duty cycle.

someone is trying to sell my a buddy a S300 not sure if its real or fake? picture attached

Were can i purchase the digital input harness? Thanks

Can you replace the stock AIT sensor with the Gm version now with the resistor? or they only work with the Analog input?

Hondata wrote:Use an ECT sensor for oil temperature. Do you mean one of the 8 analog inputs on the s300? (6?)

Very interested in this

hello, how do you set up the flex fuel to datalog the percentage and fuel temp? do you use Analog Zero still on the V3?

Is there any settings to set up in the analog inputs?

Hello, i recently wired in the GM flex fuel sensor with resistor between the vcc and 12v, it's a version 3 and wired into analog 0, my question is, is there a way to see if it's working with out running the car? And also can you get it to show you the percentage of Ethonal on the display?

Ok that seemed to work thank you, but after a few minutes the hondata switches it self From F to C by it self, very strange.. I can fix it back to F save it, upload it back to the ECU then a few
Minutes later they will start reading C again, not a big problem but just wanted to let ya'll know of the ...

I will try that in the morning.

Breaking down the voltage and C to F it was reading the correct voltage, included pics

Ok I am reading the current voltage for the EGT and also the Fluid temp. Now what do I do to get the correct temp reading?

Hello, i hooked up the PLX EGT analog out to the analog 1 wire on the S300 board, set it up in the hondata for PLX EGT but the gauge is reading a certain temp and the S300 is reading much less, is there a certain voltage offset i have to enter? Also included the file and pic