Hondata

Spunkster wrote:Post the calibration you have uploaded to the ECU

It's only a base tune if that is a factor but I'll throw it up here tonight

Spunkster wrote:So you are getting fuel and spark?

Not on kpro but on the oem ecu yes I'm getting fuel and spark

Spunkster wrote:How exactly are you checking for spark?

Have the spark plug in the coil and touch the threads of the spark plug to the motor and crank it

Well I couldn't find people around to let me throw my kpro in their car so I just used the oem ecu and cranked it with the coils disconnected and smells fuel and looked wet inside, then I flopped it, connected the coils and disconnected the injectors and it fired or a second....so Basically I need a ...

Spunkster wrote:You could try, but that my not be the best test procedure.

Well if I in plug or pull the fuse for the fuel and see if it sparks then flip and Check the fuel it should be pretty safe?...I don't wanto start the car fully on my setup with the oem ecu

Spunkster wrote:Try the ECU in a known working vehicle since you said you did not upload or make any changes to the ECU.

Could I plug the oem ecu in and see if it works

Post pictures of all the grounds.

http://i1077.photobucket.com/albums/w480/sinister-91/RSX%20Angie/C96AF8A2-CD8D-4AA0-8DAF-D5E86AB45DF0_zps49wdoqkd.jpg

http://i1077.photobucket.com/albums/w480/sinister-91/RSX%20Angie/6D8EEC54-4DD5-48A3-A3CD-731BEF1D8A22_zpscl43lxnu.jpg

http://i1077 ...

Hondata wrote:It is likely to be the engine harness ground on the valve cover. Check no wires were broken, and that the timing cover and transmissions grounds are present and clean.

I checked all three grounds and all of them checked out ok but still the same problem

Did you upload to the ECU when this happened or did you just do the things mentioned? I would go back over every single thing you have done recently as it sounds like something has been left off or put in the wrong spot.

No I did not I tried to upload it after the problem started tho, I went over ...

I'm having an issue with my 2006 acura rsx type s with a JRSC and the car was running good and all I did was change the engine oil, trans fluid, and just re-adjusted the injector clips and ground wire it is on the valve cover bolt for better ground. The one big mistake I made was I forgot to ...