Hondata

Ok i will try a new one. Thx

Or can i use the secondary one after kat? Because, there's an option in Kpro: "use secondary O2 sensor as Narrowband"?

my A/F goes up`n Down all time if i drive in closed loop...
Don`t know whats wrong :(
Please check my log file!

Is there a way to change the Volt target from the narrowband?

Very good.
Thanks

Try on a Dyno

Hello, a friend got a hondata s300. He bought it used. It was the Red board inside Ecu. The Connector wasn't there (for analog inputs). Is there a way to buy one? Or where can we buy one? Thx

This is ok 13.5:1

I think more is bette between 12.9-13.1:1

ah ok. thank you for that info.

the A/F log is dancing Lambada. is it normal?

its working now. THX to everyone

use the basemap. Just no Full throttle in high rpm beacause its lean at higher rpm

The Connector inside the ECU was off!!! Very goood!! I hope its working now. To bad wheater to test it... i dont want to drive in shity wheater ;)

heres a new datalog and calibration.

Gauge shows everything right.
Example:
I accelerate the gauge shows 13.2:1 and the log shows 10.0:1. I can do what i want... it shows always 10.0:1
If i do the settings: use analog x as wideband. Then the A/F in Datalog shows 10.0:1,too. All time

But why its showing then 10.0 only on the right analog in?

Today i try a lot things.... nothing changed. The harness at the gauge backside cant be upside down so its ok. I try the settings use analog in as wideband. Still shows 10.0 :( :(