Hondata

No, you cannot load a calibration made using other software. But you can just go to the new calibration tab and start with a stock B16A calibration and modify it as needed.

But i do not know how to make these modifications and that's something i don't want to mess and blow the engine.
The tuner ...

The s300 is a fully tunable system and you can easily upload a different calibration to it to run the other engine you are putting in.

So, i upload the map which was made and save it in .bin format and load that map on the smanager right?
And then on the Parameters tab, respectively on the Fuel ...

Spunkster wrote:Why do you need to remove just the s300 and store it for several months?

Because i currently run an b18c, but im going to swap it for a b16 to do some work on the engine. i have a map for the b16 but its not made for hondata and i only have 1 ecu.

Hi.

I need to remove the s300 v2 board from the ecu and store it for a couple of months.
Is there anything i should do to prevent problems later when i re install the s300 board into the ecu?

I'm asking this because i heard some people saying that after they leave the car in the garage for a ...