Hondata

After looking over the logs again, there is a high number of knock events on cyl 1 right before the CEL. Thank you for your help and suggestions. I'll continue to look into what caused the knock, which is likely causing the car not to start.

I have not done a compression test and the car was running 100% fine until the second this happened. I looked through the datalogs right after it happened and paid special note to knock levels after reading another thread on this forum regarding the P0606 code, but the knock levels are normal.

I ...

Yes, the upload seems to work, but the car does not start.

I can datalogging while cranking the engine and upload the logs later. We tried watching the data while we were cranking the car and we could see the injector's duty percentage. I did not check if we could see the throttle with the key in ...

When the issue happened, I tried both setting the ECU back to stock and uploading the stock "tuned" calibration but neither worked. After that, a friend with the latest version and a wireless 4g card updated the firmware on the flashpro and uploaded a stock calibration but that did not work. In ...

- serial number of your FlashPro
FP-S2K-US-30577
- FlashPro Manager version (not 'the latest')
1.6.3.0
- the calibration (as an attachment)
I don't have the file with me at work, can upload later
- a datalog of a problem (as an attachment)
I don't have the file with me at work, can upload later ...