Hondata

I am inputting it into b10. I will try again tomoro and post my findings. Thanks again.

Is there any facility for am aftermarket vss or would settings be causing my problem

Where can I enable or disable vss on s manager software

Would the removal of resistor r136-r138-r2-r3 have any effect on the speed?

Is vss a linear input?

Is there another input i can use on the ecu for the vehicle speed sensor input rather than b10. I am using obd1 ecu.
Thanks

91 civic converted to obd1 with hondata S300 v2 and I am still using the cable transmission. I have vss signal wired to b10 on po6 obd1 ecu vss signal input from my original cable input speed cluster. My vehicle speed is showing up on my plx r500 and matching the cluster speed. I have signal at pin ...

I have the same set up in my car. S300 v2 and I am still using the cable transmission. I have vss signal wired to b10 on po6 obd1 ecu vss signal input. My vehicle speed is showing up on my plx r500 and matching the cluster speed. I have signal at pin b10 on the ecu but it is not showin up on s ...

I have had someone check it. Been a long day will check again in morning. Thanks for help

i have currently tried all available analog inputs to the ecu. none of them are working for me. i have removed resistors R2 R3 R136 and R138 but still nothing working. the last input i tried was D12 and i depinned what was connected to it but then i got fault code from IAT and ECT sensors. hopefully ...

I have tried the ecu analog inputs B6 and D10 but I cannot get it to operate. D10 is showing 4.55v continiously with nothing connected to it. B6 analog2 input is showing between 1.2v-1.9v. I have connected my plx wideband to b6 analog 2 and it then turns on the A/C switch on the s manager but i dont ...

Does yes mean it can be used for closed loop running of the engine

Can the s300 v2 red board analog inputs be used for plx wideband tuning?

Can I input afr to s300 as a digital or analog input?

Has the s300 v2 got a built in controller capable of running the bosch lsu 4.2 wideband o2 sensor or do I have to connect it to the plx r500 controller and use the analog output from plx and connect to an analog input on the s300. Any help is greatly appreciated