Hondata

i tried installing it on a windows 8 AMD processor laptop before and it failed. Apparently only Intel processors are supported. Make sure your laptop has an intel processor.

No. Theyre for additional inputs that you might have.

i went back to my tune, and got the AFR's all good and smooth. still goes lean/rich under very light throttle though.

it also backfires a lot now...

sorry for delay, swapped the drivetrain into a different car because i sold the other one. still doing the alternating lean/rich. even does it at speed sometimes. is it possible its just due to a shit base map?

Thanks. ill give it a shot tomorrow. What did you change?



on this computer (not my logging laptop) i get the

"nan is not a floating type" error when trying to open smanager. ive tried searching but with no results. This computer used to be the one i logged with, so smanager used to work. any ...

whoops, forgot to add the second file.

still doing the alternating lean/rich. you can see the pulse width for the injectors going down to nothing.

my apologies. ill give that a shot and check it again tomorrow. Thanks a lot.

im trying to get my dead times right and i think ive got another issue.

ID1000 injectors
hondata 4bar map
b18c turbo
s300


The engine runs lean, rich, lean, rich, lean, rich until it gets to 212 degree's, then it starts idling fine. datalog and config file attached.



any idea's? if you need any ...

Hey. Ive got a s300v2 with ID1000 injectors. the dead times for these injectors are in µsec and in hondata are in MS. ive heard that the dead times arent quite right anyways? Whats the best way for setting them?