Hondata

Ok. I have added 2 ground staps for a total of 5 just to be sure.
1 from trans to chassis
1 from righthand engine mount to chassis
1 from valve cover center to chassis
1 from wire harness to valve cover post
1 from intake manifold to chassis
I did not see much change in voltage range, but I guess I ...

- 2000 MR2 Spyder with stock 2004 k24a2/accord cable tb
- version 4.5.9
- PRB ecu
- tsx stock calibration (attached)
- header and exhaust; no cat; PLX wideband wired to ano 2
- purchased november 23 through Healtoe
- finished the swap and the car is running so rich I have to pull 40% fuel to idle ...

Hi.
Engine - 2004 k24a2 with accord cable TB so IM is same[*]
kal: 04-05 tsx basemap
chassis: 2000 mr2 spyder
wideband: plx
Car is running crazy rich. the only way to get to idle is -40% to -50% across the board.
tps is calibrated, iacv is cleaned and working. MAP appears low, but I swapped for a ...

Recently installed HR CAI and S2 Header.
Did all of my part throttle tuning with no issues.
Then started fine tuning WOT.
There is really only one area I am having trouble with and I think it is an issue with the AF corrected or my AEM wideband.
At the 5:30 mark I do 2 pulls. Right between 4500 and ...

map

I have been running a couple of different calibrations where this has happened. The Stock - Tuned calibration from Hondata and a custom calibration I am working on.
The log is from the custom calibration but I don't think it should affect results.
At 14:43 into the log you can see the rpm is ...

I installed the newest beta version 1.8.1 the other day. Today I tried uploading a calibration to the flashpro and it says it update to newest version, which it already was.
Then, using flashpro manager I was able to upload my calibration directly to the ECU without any issues using button on ...

It does not say anywhere that a jailbroken Iphone is required. I hope this is not the case, don't really want to do that.

I am having the same issue.