Hondata

Laptop has died, I have no datalogs for the car yet. Here are my tune files that I tried to test. both MAPs tested on (2.2.7 firmware1.04) and (2.2.4 firmware1.04)

map sensor variance between tune maps was adapted to the now current hondata 4bar on the laptop. this version is exactly the same as ...

Update as of this morning...
I attempted to set up a new calibration and then just adjust the injector size. this worked fine and verified, and started. I turned the car off and then I uploaded a similar tune file to notice the same error of 6k rev limit.

I installed a different version of hondata ...

S300v1 Rev Limiter problem : ID#S300-1485

I have a freshly socketed ecu (P28-A52) automatic with conversion to manual (remove rp17-18 jumper rp18)
The board has had 2 .1uf cap. installed in places c51 / c52. not sure if this would cause the issue,
1.2K Resistor used on R54 - J1 active and in place ...

my friend had these similar issues and I pulled his board up off of the ecu and then set it back into the socket and it worked fine after. I noticed that when the ecu cover was screwed down it would budge the head unit to a point where it was acting faulty from a poor pin to socket connection.