Hondata

I have uploaded several calibrations and I'm still getting the same message. I even deleted my calibration from my laptop, then plugged in my flash drive and added it back. This was a mistake now when I try to open the calibration it causes an error and the software shuts down.

Isn't the software version that I have listed in my original post the latest?

I have uploaded the calibration more than once and this is the warning message I get "The calibration in the ecu (3.2.0.0) is from an older version of kmanager. Please upgrade the ECU calibration before datalogging from this ECU."

I've uploaded 3-4 times, and tried a couple different cals. I thought that when a speed sensor signal was not detected 49mph was the ecu default. No? Also when I load the stock k24 base map (since updating to the newest version of kpro) It says that my cal is outdated and to get a later version ...

It's set on normal. That would be the right setting since the k- tuned converter is changing the signal...right?

K-pro V3 PRB
v3.2.5
k24a2 with 05 type s trans
02 harness
K-tuned speed converter
98 civic

I'm using a k-tuned speed converter for my 05 type s transmission. The problem is that my gauge cluster is dead on mph, but my ECU defaults to 49mph which locks my reverse solenoid. Everything is wired ...