Hondata

I have been reading how to fix this issue, but i need a step by step prosedure on how to do it. 03 rsx type s revhard turbo kit 10 psi hondata map sensor, boost by gear

A dyno tunin will fix this issue

sorry

I brought kpro from club rsx.com. New. My kmanager version 3.2.5.0 and weather is 110degrees

03 rsx type s stocks engine, rev hard turbo kit60a/r turbo, 750rc injectors, hondata boost controller and map sensor 4 bar, no cat/ 5 zigen exhaust, kpro 3#12106, 37820-prb-a06/ 2068-602146.
When dattaloging on part trottle everithing is ok but when dattaloging on wot kmanager disconnects like ...

ngk laser iridium ifr7g-11ks

K manager disconnect after a few seconds when dattaloging, new spark plugs, re route ground to valve cover, kpro has insulated tape, kmanager is up to date. When this happen i have to disconnect and conect the usb cable and start again, i notice this happen close to 6000 rpm. I dont know whatelse to ...

Revhard turbo kit 60a/r turbo, 750 rc. Hondata map sensor, no cat.

What is the serial number of the K-Pro board inside the ECU? From Help, About, what version of software are you using?
Kpro v3. 12106, k manager 3.2.4
I just update my kmanager, upload the rebhard cal. Spark plug are new and now i am having a p0500 and p1106 code, now car start but when a press ...

What is the serial number of the K-Pro board inside the ECU? From Help, About, what version of software are you using?
Kpro v3. 12106, k manager 3.2.4
I just update my kmanager, upload the rebhard cal. Spark plug are new and now i am having a p0500 and p1106 code, now car start but when a press ...

Spunkster wrote:What is the serial number of the K-Pro board inside the ECU? From Help, About, what version of software are you using?

Kpro v3. 12106, k manager 3.2.4

Some pics of what I used.

The USB hub I used to get it working stable and at the moment a temporary fitting with some cable ties. Will be doing a bracket to fit it permanently onto the ECU mount and off the floor/bottom so it's out of the way of any luggage moving around and the connectors can't ...

did you make sure they were the right spark plugs.
They are the oem
03 acura rsx rebhard turbo kit,kpro 3, i just install the hondaa map sensor 4 bar and ngk ifr7g-11ks 7746 laser iridium, same spark plug from last time, i when for a run and stops recording like about 6000 rpms, i disconnect the ...

Kairu2010 wrote:did you make sure they were the right spark plugs.

They are the oem

My kpro stops dataloging, i just change spark plugs and i when for a run and now car wont start, i tried to conect my laptot and nothing