Hondata

ok so that told me a lot... even though you didn't drive in that data log I noticed something and looked it up in your calibration... your base timing on a h22 is supposed to be 15... your ignition map is set at 20 degrees... wow... I know you didn't make this map. don't think im getting on you ...

how much boost are you running???

also vtec is set super low... Datalog again this time let the car warm up all the way before datalogging... wait till the ect gets to about 180 or so before hitting the record button...

ok your map I've seen a few things.. what your seeing with the not downloaded yet just means no one has downloaded it yet to look...

What map sensor are you using??? in your tune you have stock selected... also it is scaled to 550cc injectors not 440 as you state... figure out what map sensor you ...

is there a reason why you can not hook up both... fully knowing you would only be able to use one at a time??? I guess I don't see the logic??? when the yellow wire which is your wideband signal wire is hooked up to b6 a fully functioning 0-5V input and you have the brown wire that is your simulated ...

in the parameters window go to protection and see if there is a lean protection on there... What is your wideband saying when you start up the car for the 10 secs it is alive??? if your wideband is not working due to the heater warming up do this...

1) find the red wire from the wideband and run it ...

1) Hey guys I have a question about the stock map sensor... When the car is ign on engine off what should the map sensor read in smanager??? I seem to be pulling -3.0 -3.1 psi when the car is off...

2) I'm not sure if this is related or not but I have timing locked down at 16 deg, idle is set at ...

doing it that way nets the exact same result... it doesn't matter if the car is running or not it is still going to show you base fuel pressure... I'll try to back it down to 42psi but I don't think that it will knock out 80 some percent fuel from the map... it is idleing at 10.5 I wouldn't drive ...

adjustable fpr... went to online... test outputs... turned on the fuel pump read gauge on FPR...

Hey, so I have a b18c type r full bolt on... I load up a stock itr map... try to start and I'm pig rich...10.5 or so... what fuel pressure were these pre loaded maps created with??? Timing is dead on... idle is set at 850ish...fuel pressure is at 45 when running fuel pump in options with engine off ...