Hondata

So I finally got around to installing the CPR kit today. Despite my attempts for it not to work. Like everything else I have hondata it works fine.

Thank you Spunkster and hondata for the Help. I only had one problem and that is because I changed the settings but failed to update the ECU once I did ...

So I should be ok?

You may want to edit the help page to reflect the change.

Could somebody measure the length of their coil? And I can measure this one to compare?

thanks for all the help. And I haven't even installed it yet.


steve

EDIT seal removed It measures 130mm to the inside of the ...

http://www.oemacuraparts.com/oem-part/oem-acura/coil-plug-hole/30520pvja01?search_str=30520-PVF-A01

That is the part I ordered

I cut one and does seem short. It doesn't have a tight fit at all.

I edited the first post.

steve

This is from another honda site

http://www.hondapartsnow.com/genuine ...

I ordered the CPR and the coils. I apparrently didn't look at the order to carefully and I ordered 30520-PVJ-A01 not the PVF
Before I cut the tab off can you tell me if this coil is long enough?
It says the one I ordered is a replacement for the pvf, however it seems short in length. Should these ...

Thanks for the prompt response. I don't have much confidence in my ability to remove the plugs. I may try again at the JY before attempting on my car.
But If I can't I can solder and the then just splice in later should I decide to change it out. More trouble but less trouble than me jacking up my ...

I Have a few questions before I decide to go this route or not.

I have had no luck pulling the ecu pins out without destroying the plug. Can I clip the affected wire say 5 inches from the plug and solder in the CPR side to the short wire.

Will the H22 cover hold the coils in or do I need to fab up ...

Thank you for answering.
I have adjusted the tune some and have got this a lot better. My problem was I was only adjusting the 3rd column. My second column was too low and when the car had very little load it would lean out. I have adjusted more fuel in the 2nd column and have got this to about ...

This may be a simple job for a tuner to solve. But It hasn't always been this way. I just noticed this over the past couple weeks.

I have a 97 JDMh22 obd2 obd1 dizzy and injectors stock h22 obd2 map sensor
car 1991 accord, pt24 tranny,
lc-1 wideband resistors removed. I can't remember which ones ...

I think the cruise control is controlled by another computer.

But would It be possible to use the cruise button as an on/off for datalogging?

thanks

steve