Hondata

here is more data-logs and for whatever that it may be worth, symptoms occur at idle after long load interval for some reason ... please help

Vehicle has for some reason developed misfire under load at times. At times will cause vehicle not to start but eventually does. I have checked mechanical and electrical components. The sputtering occurs at low throttle rpm. Please review and pinpoint any outstanding flaws. Any leads will help !

Update: car starts and idles fine due to spark plugs replacement install. However, will drive around block and verify everything's copacetic without any issues. They are BKRE8ix iridium, NGK2668 resistor type

UPDATE: Car starts but no culprit found so may still be CPR issue since rough idle, misfire, and non-drivable yet.

Car was fine, switch camshafts and was adjusting fuel when lean cut was activated at 12.0 around 1 psi. couple days ago. This wasn't full throttle. Few minutes later, misfire began but ...

Issue has arose, again. Day 3 12/18 CPR Issue

Unfortunately, while driving just recently vehicle developed symptom, misfire. Eventually, the vehicle won't start. The issue found related to CPR IGN red light not blinking as required. Sometimes, the red light will blink, vehicle will start, but very ...

Thanks Hondata for update and reply but unfortunately still no luck.

Alan

To be honest, don’t understand sent photo data. However, please need any tips or suggestions on what to do Hondata.

Doesn’t make sense, everything is setup as instructed. Sometimes upon troubleshooting s300 parameter setting for digital input/output, set motec sdl/adl, will upload calibration file and it will cause red l.e.d light near corner to blink continuously for some reason. Ecu is very sensitive and must ...

39031 serial number

Please reply and voltage isn’t at 60 ohms between Hi/Lo CAN wires for some reason.

2.8.4.0 Build 3515, for some reason being 120 ohms instead of 60 ohms between Hi/Lo reading.

Still need help, please.

so, please need help fixing issue.

Alan

so, 120 ohm resistor present at Hondata s300V3 harness connector prongs as AEM instructed me. However, There's resistance of 60 ohms between wires. Furthermore, I've come across a diagram photo which entails that resistor should be placed after harness connector. I doubt will make any positive ...

Please Spunkster need help