Hondata

or a bridge on the can bus just before the ecu in the center lower dash ....like i do with solder and clips.... less effort and cut on hands

waiting for :)

Soldering is the working way :) immo paired with ecu time to install all stuff. Cos i can t find fast clips to clamp on wires may be next time i ll do that

i'm thinking i was good but cos not working i ve take decision to soldered it on e connector. and i m sure it's good now just need to test with my dealer on tuesday

i've soldered hondata harness on E connector
- red on Low can (red with 2 grey dot )
- white on high can (white with 2 grey dot)

and test with the flashpro now he's just says : "can't find VIN in ECU".

I think it's better than before cos i had another kind of message before : "fp connected but ...

smaller like it's wrote on cable

same problem bro i take the car with rbb a21 to dealer and he can t pair the unit with the immobilizer. And when i connect my flashpro it said flashpro is connected but need to turn on vehicule (state before motor running) else i'm at that key position.

DOn t know why and i ve follow hondata ...

i go to my dealer today and he can't pair my rbb-A21 with my car immobilizer !!! my ecm is an rbb-e05... don't know why !!! i already mouth the hondata harness don't know where does the problem come from ...
Any ideas mates ?! (may be my dealer sucks ....)

thx mate :D

can't find the same connector than u k_a_n_o near steering columun with empty room in my cl9 type s (lhd)... :s