Hondata

Alright, the software solution sounds good since I'm traveling out of town for 2 days tomorrow morning. If this won't help I'll send you the whole ECU incl. KPro, hopefully I wont have to.
Are you going to reply about the software on this thread or by email?

Thank you for the fast support by the ...

Upgraded. Still no luck.

I have just used the "Send Support Information to Hondata" function, waiting for a reply!

Regards

Hello,

I havent used the application for a while. Now of a sudden it requires a password which I havent set at all when I try to upload any calibration.
I've tried contacting CPL Racing, but havent gotten any answer.

Also under the "Registered owner" area I've got some weird letters (attached pic ...

Hi,

When I reach rev limit, I want ignition cut instead of fuel cut. Is that possible with Kpro 3?

/Sam

I dont mind sending the ECU/Kpro to CPL again, but what if there's no problem with it? What could it else be? Incompatibility? I've tried uploading a cal with a Win7 32bit and 64bit and with a Win XP PC. Got the same problem. One thing I've noticed is that, when I plug in the ECU and turn the ...

Spunkster wrote:I would recommend taking this back to CPL so they can Check it out for you and make sure everything is working properly.

Alright. Have a question though. Kmanager says i have : ECU Type: PRA Euro Civic Type R. But the original ECU i have is PRC. Could that be a problem?

What is the serial number that is on the K-Pro board inside the ECU? From Help, About, what version of software are you using?

I got version 3.1.6.
For the serial number, do I have to open the ECU to access it? I dont want to remove the sealing i have from CPL Racing. Is there another way for me ...

Hi,

I have the same problem. Just got my kpro for my jap ITR DC5 and downloaded the newest kpro. I tried updating the USB drivers via the menu but i get; "Error updating USB driver (Error:)". Doesnt say anything after the colon. The drivers were installed when i plugged in the ECU to the usb though ...

Click on the button in the software that says New Calibration and then select the K20A-ITR calibration. IT is the closest to a PRC calibration we have.

Will that calibration work fine? Im an amateur and just bought a new K-pro for my jap itr -03, do i need to adjust something with your k20a-itr ...

Click on the button in the software that says New Calibration and then select the K20A-ITR calibration. IT is the closest to a PRC calibration we have.

Will that calibration work fine? Im an amateur and just bought a new K-pro for my jap itr -03, do i need to adjust something with your k20a-itr ...