Hondata

That is the only way to set the targets. You cannot set the individual columns separately. It does interpolate between the values so there really is no problem with how this works.


The problem is that the feature sucks.... It really wouldn't take a lot to allow each column to be adjusted ...

Hondata wrote:We can test it again, but we have not made any alterations in that area and I would expect it to work. It will take us a few weeks to be able to test this.

:)

Hondata? How did your testing go?

Thank You

Maybe it has since been broken? There isn't much to hooking it up correctly and outside of Hondata I have only found one person who has had this functioning (PLM WB on the positive input), including the OP myself.


http://www.hondata.com/forum/viewtopic.php?f=19&t=17448&p=75613&hilit=Digital#p75613 ...

Any resolution to this? I attempted to make this function on my V2 board with ZERO luck. Seems that it is incompatable with Innovate sensors.

TX from cable to I- on S300 and GND to GND no responce /
Sensor does communicate through serial port using Logworks

Square, I have the correct version of hondata (S300J V2) and small square JDM ecu with the +12V output. I understand how to complete the hardware portion of the installation, I do not understand how to configure and adjust the software portions (SManager).

Thank you for your speedy responce

Has anyone used a P72 IAB output to control boost solenoid, I see that it has recently been added as a feature. I have tried to use this feature on other platforms with not much success. Any advice how to set this up, other than clicking enable boost and he variable frequency box?