Hondata

Hi,

Would you mind help me to configure in the S300 to disable Vtec please ?
What do you advise on SManager to be configured ?

Thanks

Hi,
Just Bought and fixed the AEM pressure sensor #30-2130-150.
Could you please assist me to configure it on the Analog input ?
Which voltage should I put I can also put 2 values.

Thks

Hi,

Could you advise me any Coolant pressure sensor and wiring / parameters to S300 V3 ?

Thks

Hi,
It works with normally closed and std diagram
Thks
40% I'm around 23-25 PSI

Does it work also if I set normally open and invert connections A&B on wastegate ?

Thank you,
And plugged as below for Wastegates ?

https://www.hondata.com/images/hondata_ ... ctions.pdf

Hi,

I have a problem to control boost with my Twin 44m.
Running Hondata 4port solenoid
I plugged ad this diagram below with a T
https://www.hondata.com/images/hondata_4_port_boost%20control_instructions.pdf

and can't control my boost, that makes no sense at all I barely get 2 or 3%, Either 1 b or ...

I changed my gera ratio in Gear comp and it works.
But the module recalculate doesn't work on gear comp, how does it work please?

It seems working.
SCS sensor jump to ON when I shift, It switches to ground.
at idle it is a very little cut, Around which duration is good?

Hi,

On hondata S300 display the gear engaged is not the good one.
Do you know how to configure it please ?
Thks

Than you Spunkster
So I need to connect both wires (blue and red) to one anolog wire Input of S300?
Then configure it in Voltage?
Thks

Hi,

I have this Flatshifter and would like to ask how to configure it please on S300.
https://www.flatshifter.com/flatshifter-strain-gauge-gear-knob/

I have a 2,5V Amplifier module and 4 wires.
+ Battery
- Ground
Red wire for Upshift
Blue for Downshift

Flatshifter answer below:
As you have a H ...

Just changed my laptop and needed to download the new version and need to switch lots of setting.
I saw lots of others options and I m afraid to connect my new laptop to my ECU.

Hi,
Where can I download old software version as 2.0?

Thank you

What rpm do you setup your brun out rev?