Hondata

Ok, I'll do as you told me.
thanks a lot for your help.
I'll let you know the result :)

I want to target between 0.5 bar and 1.7 bar boost but it's a lot of values for the case can

Hello,
so here, I set the frequency on 35 hz then I increased the duty of 1% in 1% because 5% in 5% it was too much.
here are the results:
IAT at 5-6 ° C, sensor before throttle (7am)
outside temperature 1 ° C
20% 1.32 bars
21% 1,36 bars
22% 1.41 bars
23% 1,50 bars
24% 1.51  Bars
25% 1,60 bars
26 ...

from how much boost should I start my table? the minimum I want to have?

Ok
for you how much should I put the frequency of the solenoid?

I had forgotten, I noted the pression in (Graph) and I fill the table as I increase
the duty

if I understood the Hondata manual correctly, I did the following method:
I note the value of the solenoid boost disconnect but recorder to the pipe, then I reconnected the solenoid.
I found 0.250 bar
I put in (fixed duty cycle) at 10% for the departure. --- 0 boost
15%. --- 0 boost
20% --- 0 boost ...

yes I did as they say but as it's technical English it's not easy

Hello,
I did some research and I did not find anything,
you tell me my painting is badly filled (from 3.4 psi to 25 psi), so what do you think it will look like?
I would like to be able to boost up to 25-27 psi

I will do a datalog as soon as possible

here is my calibration

Hello,
excuse my bad English because I am from the south of France (google translation).
here is my problem:
I can not adjust boost levels based on gears when the engine is cold and when it is hot; I have very high levels when the engine is temperature (about 10 km of driving) then the levels drop a ...

hello, I have put my engine in my car, I went to the option as you told me and it fonctionne.thanks for your help.thank you very much

ok! I'll do that as I have reassembled my engine. I'll let you know