Hondata

"Shift+F1" button to go to normal table doesn't work, it goes to Hondata Guide page (SManager Help Contents). it didn't happen on prev software version and i didn't change any keyboard shortcuts as well.

Solved, thank you so much Spunkster.

when switch to high speed fuel table it goes blank, no afr can be recorded, can you see it at my datalog that i posted.

thanks for reply spunkster

-S300 V2 serial number 20894
-ECU P28
-Honda Civic 3 doors 1992 D16Z6 NA
-Std air filter, Skunk2 intake manifold, Skunk2 TB ,Hondata intake man gasket,Standard Injectors (240cc), AEM Uego wideband O2

Software SManager 2.2.7
When i was doing data logging, after the table switched to 2nd table (high ...

Sea level, anyway i got an email from hondata support was talking about restricted air going into my engine. I will give you an update, thanks Spunkster.

Hi Hondata

-S300 V2 serial number 20894
-ECU P28
-Honda Civic 3 doors 1992 D16Z6 NA
-Simota Open filter, Skunk 2 intake manifold, standard TB ,Standard Injectors (240cc) ,Aem Fuel rail, AEM wideband O2.

During datalogging on street, i couldn't reach the last column on WOT, it was staying on 9th ...

Spunkster wrote:Use D10 as it will be able to properly read the full range of voltage for closed loop operation.

Appreciate your help...

Any of the inputs listed under Closed Loop in Parameters. Do not use D14 though as it can only read about halve of the voltage range.

I have 2 O2 sensors in my car, 1 attached to D14 (NB) and 1 to the D10 (WB) , if i want to use WB for close loop daily , should i move it to D14? Or i can keep it ...