Hondata

Sadly everyone I've asked has had the same response.


"uh..."

[*]Kpro SN 11485
PRB-A085
2068-512381
2002 Acura RSX-S
AEM v2
Hytech header and exhaust. No cat
Kpro is new

So I got the kpro to work while engine is off, but if you try to start the car and leave the display on it will not stay online. Goes off and on. What can I start to look at for the cause ...

So just for the sake of any other noobs like myself that didn't think about it, it was an ignition wire at the harness near the ECU. A friend told me to check some other wires and while under there I happened to see a black wire with yellow stripe that had been cut and soldered at one time. Previous ...

Ugh. The kpro connects fine in the EP3. I can't see anything else to check on the car...
I uploaded the file needed to start the RSX. Put kpro back in RSX. no start. So the calibration is on the kpro. Something my car is doing is pissing it off.

Ok I can try to install it in my EP3 to see if it connects properly but I can't upload anything because I don't know where the .kal file is for that tune. I have it somewhere but not sure where. (might have been on the laptop that's broken). Battery is dead on the EP too so that may take a few ...

No. I've been driving it for two years and I had it towed to the dealer when I bought the car and bought the key from them.

I spent all day reading and searching. I could not find a solution that worked. I just received my kpro about a week ago. Just installed it today. It's not recognizing the ignition on. I cannot upload to the ecu, but it let me upload the owner name and settings. The normal buttons for uploading and ...