Hondata

Thank you for your time and support.
Kind regards

Thank you for your support.
calibration sent.

Hi
Please excuse me.
I`m wrong it`s VTP on. In the log sent to you I see VTS off VTP on.
Is this a problem?
Regards

Thank you for your support.
I disable Vtec and now its running better. What I see now is the Vtec is off but VPN on.
I don`t know what VPN is, and please forgive my ignorance.
Now I see its working better but don`t know if the voltage at high it`s right.
Let me sent you the log I did last night ...

I check the program and Vtec is not enable. We run killer Vtec cams and we have Vtec and Vtc disable.
Is there something else I have to disable? Wil this be the problem for low voltage at High Rpm?
Regards

Thank you for your answer. I`ll take a look. It should be all time off.
Kind regards

Hi
I`m searching for some info about voltage at high RPM. Over 7000 RPM what voltage the Kpro needs ?
Looking at the datalog I see 12.9 volts . Is this correct or we have an electrical problem. I check
all grounds an install a new main relay and battery. At the battery the voltmeter always shows ...

Good night.
I`ve read the documentation trying to hook up NGK Gen 2 to Kpro V4.
It`s being impossible to log so I decided to change to an AEM wideband
35-3401 and this one as the NGK gen 2 it`s not listed on KproV4.
Maybe you know the voltage offset to this AEM wideband.
Kind regards

Thank you for your help. I check the documentation and found the voltages.
I will do it and see if works.

It`s NTK Air fuel Ratio Monitor Gen2 with it`s sensor.

Thank you for your answer. In all the instructions I don`t any info
about the voltage conversion. I`ll check again or maybe you can tell
me what voltage conversion to apply?

Hi
I`m trying to hook up Wideband NTK Gen2 to Kpro.
I`ve seeing all wiring diagrams and try the diagram as
for NTK AFX but the AFr info at KproV4 is not the same
as the one in the wideband monitor.