Hondata

I'm most definately not a programmer, or an engineer.

In saying this, would it be possible to use one of the inputs to pick up the knock from a sensor? With software, allow this in the program?

Just a question,

I'm sure other individuals would also like to know. With great leaps in technology, and with other tuning systems having it as an option, knock control is lacking with the s300.

Wondering if it is or will be a consideration i n the future?

Thanks.

Hello again,

Got new injectors, set them up as requested by manufacturer. ID 1000s on S300.

Can you look at this log, I believe they are staying open too long after TPS goes to 0%. If this is so, should I adjust up of down on the deadtime. Cruising it's fine, when I let off the throttle my AF's ...

Well....finally got the damn thing figured out. Thought I would post my results incase someone else ran into this issue.

Step 1 : Replaced Ignitor with known good honda OEM part...no change.
Step 2 : Replace Coil with known good honda oem part....no change.
Step 3 : Got upset
Step 4 : Gutted my ...

.028 with the BKR7E.

I will attempt to resolve the issue. I very much appreciate the help on this. Will keep you posted. I actually have been logging even at idle and I see it as well there.

Thanks

So here's the latest and greatest in regards to tune. RPM still erratic.

Any other ideas SPUNKSTER? Thanks.

Will advise and go from there.

Thank you.

Thank you for the assistance in the matter.


As follows:
Serial # S300-8724
Calibration: as attachement (tuning high cam now)
Datalog : as attachement
ECU : 37820-P28-C02
Affecting Mods : Boost Gauge, EGT (both ProSport), PLX W/B, GM solenoid, Jumper Harness (ECU and Dizzy) D16z6 conversion from Y8 ...

Hello,

I have been attempting to tune my car, here's the fun part

I get erractic fluctuations in the subject stated areas and ONLY under WOT above 4k . Part Throttle no issues all the way to 5k+

Any ideas please. Same S300 I used on last build, checked grounds, new cap and rotor (OEM). Only ...

I had this happen. Go to your vault and set up a password. Took me forever to figure that out since it had been a while since I updated my software.

Hope that helps.

I figured it out, had to upload the log. Once that was completed, had to exports and rename it to export as a CSV.

Thanks

Exporting for virtual dyno.

Hello,

I have been trying to export my datalogs from s300 (s3d files) SMANAGER, to csv files. Can't figure it out...
Looked over help section and forums, can't seem to locate anything. I enter my calibration, then load my datalog to see it with graphing section. That all works, when I attempt to ...