Hondata

ok just installed a grounding kit soo i kno know every part of the eninge has excellent ground direct to the battery and still having this issue...

is it possible my tune is soo far out that it cant make these corrections, it was tuned in colder weather... but it shudnt be adding fuel tho, shud be ...

Yes I've tried every input...

What grond would I start with...which one is for the ecu...and shud my wideband be grounded in logiic ground on the ecu

Currently aem uego is connected and battery may have been slightly low when first started.

What kind of electrical issues would affect the input signal...a ground?

here i have proved 4 datalogs 20sec each... 2 at cold start and 2 at operating temp, both temps i logged open and closed

calibration

b18c with 84.5mm pistons
gt37r
1000cc dynamic injectors
skunk2 pro1 cams
hondata 4bar map sensor
68mm tb

We've been over everything and pretty much on the same page...do you work for hondata? Absolute worst service I've ever experienced...don't want a bad wrap of hondata going around do you?

why post that link?

what if i raised the short term fuel trim settings higher?

going to be calling during the week soo i can actually talk to some one

I had this problem when I first got my car tuned and it wasn't working properly. They suggest I conract hondata for answers

Can I adjust the settings on the short and long term fuel trim or do I need another map made up because this current map was done in the fall so it was colder

hooked up aem wideband today, i am now receiving perfect signal thru to hondata.... but problem still occurs when i put it into closed loop that the car runs at 10.00afr

thinking it might be some type of electrical interferance of sum sort or wiring problem... wut does closed loop engage when it ...

i removed r138, r136 was already removed...still no luck with closed loop.

wiring is all done correctly, wideband to d10... d10 selected on hondata.

are my parameters correct? even tho nothing seems to change when any number is changed on the s300, continuously runs at 10 when closed loop is ...

ive upgraded new version and still no progress,will post another datalog.

If the resistors arent removed,I think they are r136 and 2 Others..... Would this cause this issue I am having... What are the correct resistors to remove I will check..
Is there a number I can call and actually talk to a ...

just downloaded newest version, going to play around tomorrow and hopefully get results

1.4.0.0