Hondata

Did you get this resolved? Curious because my coolant temp gauge on the cluster started acting strange today. It cycles from 0 bars to 7 bars almost on an exact time schedule. KPRO reads 185-188 straight through.

Prior to today, I’ve never had any issues with it. I’ve had a KPRO AP1 for 5 years.

I "Fixed" this issue. After spending close to 10 hours total trying to re-ground and rewire everything, nothing worked. What I ended up having to do is change the slope of the input to Kpro. I spent 2 hours datalogging deviations in the reading from the Gauge & Kpro.
What I did was changed my Idle ...

sorry for the late update. i forgot about this because i havent used flashpro in a while. most recent update is always in use. i update every time i get the prompt. issue still exhists, though.

having an issue with kpro analog inputs from the failsafe. i am using channel AN7 to white failsafe for input , and 1 of the AN grounds to Brown failsafe input ground. the gauge ground and other AN ground is on the ground cluster bolt by the hood release lever. my issue is firstly, i need a voltage ...

I've been having an issue with flashpro manager for a while, where anytime I save a calibration after I am done datalogging/tuning a car and then close out of flashpro manager, I have an issue reopening the calibration, it always says "the file appears corrupt". Every time I want to datalog/tune a ...

Thanks, Email sent.

EDIT - edited original post with correct serial #.

No help?

http://www.hondata.com/forum/viewtopic.php?f=12&t=10396


after searching for hours, THIS is the EXACT issue mine is having right now. along with the Error every so often.

3rd picture Above shows the Error in bottom right hand corner.

I tried to do some data-logging today, And had absolutely zero luck. This is the first time I've tried since I had the CEL issue. I'll post some screen shots, but long story short, neither one of my laptops would/could recognize the ECU. I tried multiple times to update drivers, uninstalling/re ...

Put copper Resistor plugs in. I'll drive it around for a couple days and do some data logs and see how it goes.

Ok. Will do. Someone else mentioned my transmission ground too(I have big 3 though). I'll try to get both done tomorrow. Thinking I have a bad plug?

Not at all. I do all my data logging around my house(10miles or so) and usually go inside my house to make my adjustments, that's why it usually didn't bother before until lately, because of the more serious issues.

NGK IR IFR7G MKS. laser iridiums.

I'll pull a plug when I get home.