Hondata

That is correct I have it set like in your pic. Thanks John

How should they be set to make it work.
I have tried many combinations
In sensor overlay one lambda
and if I use sensor overlay 2 what sensor should I be using I have tried af with no luck
Also when I change sensor overlay do I have to cycle the car on and off
Thanks John

innovate l-c1 wideband and input on d14o2.
everything has been working for the last year until last night. Thanks John

Hi attached datalog and map.
the lambda datalog tables are not working
as well as the percent to reach target lambda.
the boxes are highlighted when I drive but there are not any values in the box
Thanks John

nobody? I thought maybe I hit the wrong button. Is this something I need to send the s300 in for? If I look at past datalogs the percentages are there. The percentages dont show up if I am datalogging or not now. Thanks John

Hi,
I was out tuning yesterday and getting a lot done, well the problem is today when I started to tune the table that shows estimated fuel to reach target lambda is not showing percentages in the blocks, the blocks are highlighted as I vary engine rpm but the percentages are missing.
I'm sure its ...

Hi I have been running hondata version 1 in my del sol for several years, well I got a new version 2 for a new 95 hatch with a b16 everything works fine but the ac compressor is constantly running no matter where the controls are set inside. All the aux and nitrous inputs are turned off. I then ...

Hi I just got a new mac computer I got windows xp installed just fine and loaded the s300 program I went to update drivers and everything looks fine. I can open a file make changes but cannot get it online so I can load it on the ecu. I checked my cable and its good any ideas? thanks John

Hi I have a Hondata s300 v:1.5.4 #13151 that after 8 months of running perfect, I went out to start it and it would not run long story short the red light was on and it had to be sent in for repair, my question is can I burn a copy of my map on the s300 to a chip so if I have problems in the future ...