Hondata

I logged in to ask for this and found this thread instead.
So yes, waiting too.

Same here, as already mentioned last year on this forum...
LC-1 hooked up to S300 V2 (SManager v2.3.3). Readings from the digital input are half of what is shown by LogWorks or logged on analog input (i.e. AFR=14 gives a reading of 7 on the digital in).

Hi,
any further thoughts?
I'm running out of ideas here. It's a single data wire - not much space for errors.
Besides, any grounding or interference problems would results in more erratic output, right?

LogWorks is working fine. Also, it seems I'm not the only one with this problem: http://www ...

sure. The terminator is in. LC-1 to S300 connection is just the data wire, i.e. no ground. Both S300 and LC1 are grounded at the same point.

Hi,

I just have wired the digital between LC-1 (firmware v1.20) and S300 v2. All OK, except that the units are not right:
- on the laptop (Windows 7) used to update calibration and datalog: the AFR from digital input is twice as low as analog input from B6. The output from LC-1 is OK, because ...

Do I understand correctly that the additional digital/analog inputs on the v2 are for datalogging only? i.e. I need to connect the wideband to the ECU pins to get lean protection working?