Hondata

I did reinstall the 3.0.3 software with the exact tune from the high octane tune from your factory installed calibrations, the vehicle has ran fine since the old software install. just turned immobi off and knock flash when detected and thats it for now.

I just installed the new software to the kpro. The vehicle will start for a little bit and die. i pulled out the factory ecu and it ran just fine. the vehicle ran just fine with the version 3.0.3, and didnt know if i could get the 3.0.3 software back to see if it runs just like it did before the3.1 ...

serial #: 05008241

that one is on the outside of the ecu.

there is an inside one that has the same part number but below that is 1412253x17

141225-3y10

Serial number: 8241
Ecu:37820-pnf-a12


Intake, delete cat, skunk 2 exhaust, 8 pound flywheel, 6 speed trans (02-04 type s)

I will get that to you later I am an hour away from it and at work till 6'ish eastern time. Sorry about that.

I can also datalog the ecu and monitor all sensors, plus upload any calibration just fine.

I have recently recieved a hondata kpro from a friend and it has a cylinder 4 misfire. I have the factory ecu in currently and runs perfectly fine. i have tried switch coils and plugs, all the injectors have 13ohms (its a factory injectors from an 05 civic si with k20a3). it is getting spark to the ...