Hondata

J12 is cut, will order the caps get them done and report back.

I uploaded a calibration from 2+ years ago that worked fine. Only change since then is the version of software/firmware.

Still doing the same thing, there is no secondary tables enabled.

Here is the calibration and the short datalog.

1st gear pull, hits rev limiter and goes limp you can see it ...

I was definitely live tuning with this calibration that I uploaded.

Should I delete the calibration from the s300 then do a re-upload?

Not sure what else to try.

It's a straight LS setup... never used secondary tables before...

Not sure why the datalog is showing them

Please see attached. The photos and the datalog are specific to 1st gear rev limiter, but I've experienced it anytime it spins and hits the limiter, 1st and 2nd gear typically.

The photos are from 20mins 38secs of the datalog I uploaded.

Thank you in advance!

I've had this setup for quite a while. I got it back on the road after a few months. Broken intermediate shaft etc.

Anyway I uploaded the new hondata firmware/software and went for a drive. If I hit the rev limiter in any gear, the RPMS fall on its face almost like a boost cut, then it gives me a ...

Hello im assuming this is a software problem. With version 1.8.5 as well as 1.9.2 beta and now 1.9.3 for us civic si whenever I download a datalog from flashpro as soon as I look at lambda overlay values I get stuck on that button it remains highlighted. I can click on normal values or lambda but.it ...