Hondata

Okay, I cleared security again and reset the computer before uploading. The upload took ~1.5 minutes. Still no start.

I plugged in my stock ECU and the car fired up right away.

Is it too early to start asking about Hondata's service/repair/warranty policy? :(

The stock ECU was working fine before I installed the KPro. I can re-install it and check it out again when I get home.

Do I need to switch the primary O2 sensor back (to the 05-06 version) before I attempt to start the car with the stock ECU? Or can I safely start the car with the stock ECU and 02 ...

Version 1.4.5.7, May 2011

Cal file attached.

Another noob question ... do I need to unplug the immobilizer (from beneath the steering column)?

Okay, found one more clue to the puzzle. I pulled a coil and checked for spark while cranking the engine -- there was none. So the question is, what would cause my coils not to fire?

Spunkster,
Just tried it -- it didn't work.

I downloaded the cal from the ECU and compared it to the cal I uploaded ... here are the differences of note:

Line 21:
SoftwareVersion=5207
SoftwareVersion=5136

Line 23:
Checksum=1112211714
Checksum=1586364804

Line 569:
LaunchMaxSpeed=2
LaunchMaxSpeed ...

Datalog of attempted start:
http://dl.dropbox.com/u/28120097/attempted%20start.kdl

inside of KPro, serial # reads 05004952
https://picasaweb.google.com/lh/photo/r4Sy-qm5zrEVUAz7ySE5_bgjHNGJOrGMhpR22vyCrQ?feat=directlink

https://lh6.googleusercontent.com/-LByM7-KG3sY/TdsWilU882I/AAAAAAAABqM/D1Oo8ouUWyM/s640/IMG_20110523_191738.jpg

wire harness
https://picasaweb.google.com/lh ...

Hello,

I just installed a 05-06 KPro into my 06 RSX-S, and now the car cranks, but will not start.

- I replaced the primary O2 sensor with an 02-04 version.
- Uploaded the 05 CAI kal that came with KManager, unchanged.
- Immobilizer is disabled (check box was already empty in the kal I uploaded ...