Hondata

I just repinned the harness for the sensor and it works for what I need.

Says I'm doing 156 MPH at about 10 MPH, but that's fine for what I need - reverse to work, VTEC to engage (at "100MPH"), and possibly launch control down the road (below "75 mph").

Am I missing anything that is a problem with ...

Any suggested switches for a clutch switch for WOT shifting and two step? I've got an Ariel Atom with a PRB K-pro, a K24, and Tilton pedals. Just looking to know if there is a product out there that people have had good luck with. I'm seeing everything from $1.50-$150 switches on Google and Summit ...

I have a brand new PRB K-pro that is running in an Ariel Atom.

I have a K20z3 tranny with the high frequency VSS. I also have an external VSS (magnet on the half shaft) that drives the speedo on the dash, so I have little need for the VSS.

I have disabled VSS in KManager, so it defaults to 49 MPH ...

Where does Ariel normally mount the ECU?

Even if you seal around the case and wiring, the connectors are not water resistance. ECUs which are waterproof, like from the 2006+ Civic, have a rubber seal around each pin in the connector, and the case has not open screw holes.

The best thing to do is ...

I'm running a K-pro in an Ariel Atom. Bottom line is that there is nowhere in the car that is dry, so I have to mount the ECU "outdoors"

I'm planning on running it vertically behind the drivers seat mounted to the firewall. It's the most protected place I can find.

Where is the ECU vulnerable to ...

I'm hopefully finishing the assembly on my Ariel Atom driveline in the next few weeks, and am looking for a Kpro map to get me started on a breakin without washing down the rings.

My setup is:
ERL 12.5:1 K24A2 87.5x99
Team4Piston K20A2 head, flows 360cfm in my cam lift
Kelford Cs (very similar to a ...

Spunkster-

I've already got my ECU, wiring, TB, etc to run everything as a PRB. I'm not going to be using a Flashpro. All I need to know is if the newer O2 sensor is compatible.

Jason

It's a 2011 Ariel Atom, with a K20z3 style setup. So the original ECU is a K20z3; however, I bought just a roller and am putting in a K20A2 head/harness/ecu on an ERL built K24A2.

Thanks,
Jason

My Ariel Atom came with this O2:

Denso
Du5
211200-2650
12k11-09
Usa


Will that work with an 02-04 PRB ECU?

Thanks,
Jason

Hi-

First post here. I am building an Ariel Atom as follows:

2011 Ariel Atom rolling chassis
K24A2 shortblock built by ERL
K20A2 head CNCed by Team4Piston
74 MM HR TB on an RRC intake

I'll be running a brand new K20A2 harness (32110-PRB-A00), and already have my K-pro - PRB-A05, Serial Number ...